Traversing Ranges - Siemens SINUMERIK 840D Function Manual

Range of values for feedrate for positioning axes:
Metric system:
0.001 ≤ FA ≤ 999,999.999
[mm/min, mm/rev, degrees/min, degrees/rev]
Range of values for spindle speed S:
If the computational resolution is increased/decreased by a factor, then the value ranges
change accordingly.
2.2.2

Traversing ranges

Range of values of the traversing ranges
The range of values of the traversing range depends on the computational resolution selected.
For the standard assignment of machine data:
MD10200 $MN_INT_INCR_PER_MM
(computational resolution for linear positions) (1000 incr./mm)
or
MD10210 $MN_INT_INCR_PER_DEG
(computational resolution for angular positions) (1000 incr./deg.)
The following value range can be programmed with the specified resolution:
Table 2-1
Linear axes X, Y, Z, etc.
Rotary axes A, B, C, etc.
Interpolation parameters I, J, K
The unit of measurement of rotary axes is always degrees.
If the computational resolution is increased/decreased by a factor of 10, the ranges of values
change accordingly.
The traversing range can be limited by software limit switches and work areas (see Function
Manual
For special features for a large traversing range for linear and rotary axes, see Section "R1:
Referencing (Page 291)".
The traversing range for rotary axes can be limited via machine data.
Further information:
Axes and spindles
Function Manual, 06/2019, A5E47437747B AA
G2: Velocities, setpoint / actual value systems, closed-loop control
Traversing ranges of axes
Monitoring and Compensations , Section Axis monitoring ).
2.2 Velocities, traversing ranges, accuracies
Inch system:
0.001 ≤ FA ≤ 399,999.999
[inch/min, inch/rev]
0.001 ≤ S ≤ 999,999.999 [rpm]
G71 [mm, degrees]
Range
∓ 999,999.999
∓ 999,999.999
∓ 999,999.999
G70 [inch, degrees]
Range
∓ 399,999.999
∓ 999,999.999
∓ 399,999.999
33