Table of Contents
Advertisement
9. Connect the single fiber, patch cord, or fiber link
to the launch cable connections as shown in
Figure 6-7. Loss measurements will be displayed.
Fiber to be
tested
Figure 6-7. Making loss measurements in Manual Loopback mode.
Do not remove the test jumper from the Fiber Meter TX port
after the reference is set.
10. To obtain the loss measurement at the other
wavelength, select that wavelength at the Power
Meter unit.
CHAPTER 6: Extended Functions
Bulkhead
Adapter
Test Jumper 1
NOTE
71
Advertisement
Table of Contents
