Set The Number Of Connections - Black Box Fiber Meter Manual

FIBER METER
If you select two-way testing, Autotest pauses after
completing the first set of loss measurements so that you
can swap test jumper connections at both ends of the
fiber. See Chapter 5 for specific information about
Autotest.
1. Set the rotary dial on the Main Unit to SETUP.
2. Press the up- and down-arrow buttons until Test
Mode is highlighted.
3. Press the F4 button to toggle between OneWay and
TwoWay.

3.2 Set the Number of Connections

Specifying the number of fiber link connections, splices, and
the fiber core diameter establishes the loss budget for
multimode Autotests. See Chapter 5 for more information
about Autotest.
1. Set the rotary dial on the Main Unit to SETUP.
2. Press the up- and down-arrow keys until # Of
Connections is highlighted (see Figure 3-3).
24
IMPORTANT