Table of Contents
Advertisement
FIBER METER
8. Press the F3 button on Fiber Meter Unit B to
select 1300 nm.
9. Press the F4 button on Unit A to set the 1300 nm
reference.
The Manual Power Meter mode allows you to set an optical
reference. The Manual Power Meter reference is only
retained while the unit is in the Manual Power Meter mode.
Setting a Manual Power Meter reference does not change
an Autotest reference set using the CAL function. See
Chapter 4 for specific information.
10. Connect the Fiber Meter handsets to the installed
fiber as shown in Figure 6-4. Loss measurements
are automatically displayed.
66
NOTE
Advertisement
Table of Contents
