Set The Circuit Names - Black Box Fiber Meter Manual

FIBER METER

3.14 Set the Circuit Names

Circuit Names sets the default name used for circuit
identification when saving Autotest results.
1. Set the rotary dial on the Main Unit to SETUP.
2. Press the up- and down-arrow keys until Circuit
Names is highlighted.
3. Press the F1 button to select NONE, the F2 button
to select BLANK, the F3 button to select NEXT,
and the F4 button to select SAME. See Figure 3-4.
The available selections include:
• NONE. No Circuit ID is used. A sequential tester-
assigned report number is provided.
32
Figure 3-4. Circuit naming.