Black Box Fiber Meter Manual page 36

• BLANK. No circuit ID is entered (not even a
tester-assigned report number).
• NEXT. You can enter a Circuit ID that's one
number, letter, or number/letter combination
greater than the last ID used. If the last ID used
ends in a 1, the next ID will end in a 2, and so on.
If the last ID ends in a B, the next ID will end in a
C, and so on. Numbers used can be 0 through 9
and letters used can be A through Z.
• SAME. You can enter the Circuit ID that's the
same as the last ID used.
If you use NEXT, and the Circuit ID that's one number (or
letter) greater than the last ID has already been used, the
circuit ID that's two numbers or letters greater than the last
ID will be entered.
Notice the following example sequences:
ID-ABY
ID-ABZ
ID-ACA
NOTE
ID-AB8
ID-AB8
ID-AB9
ID-AC0
CHAPTER 3: Setup
33