G) Activating The Speed Controller; H) Attaching And Fastening The Car Body - Reely ROAD EB-04L Operating Instructions Manual

g) Activating the Drive Control
Switch on the speed controller (see chapter 8 f, figure 1) Then wait for a few seconds (leave the throttle/brake lever on
the transmitter in the neutral position; do not move it).
If the drive of the vehicle starts although the throttle/brake on the transmitter is in the neutral position, then
adjust the trim on the transmitter until the engine stops. If the trimming path is insufficient, the neutral
position must be programmed, see chapter 10. a).
Now check the drive and steering function of the vehicle.
For programming the speed controller, please observe chapter 10.
Chapter 10. a) describes how the neutral and full throttle positions for forward and reverse driving must be
set. This should be done at first start-up if the steering servo does react correctly but the vehicle's engine
does not start.
Chapter 10. b) describes the other programming possibilities for the speed controller (e.g. braking function,
etc.).
Important!
If using a LiPo driving battery, you first need to programme the undervoltage protection. Only then
can may you drive the vehicle.
Otherwise, the LiPo battery may be subject to deep discharge, which will damage the battery.
h) Put On and Attach the Car Body
The vehicle is delivered without a car body. Thus you can decide which body you want to install.
If the car body has no attachment holes, drill them in the respective positions with a suitable tool. Furthermore, you
need to drill a hole for the aerial tube.
Set the car body splints to the right height so that the car body will later be in the desired height.
Push the aerial tube from the bottom of the body through the respective opening. Put the car body onto the supports
and secure them each with safety clips.
Your car is now ready for its first test run!
42