Reely ROAD EB-04L Operating Instructions Manual page 60

The vehicle doesn't drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
Steering or driving motions opposite to movement of steering wheel and transmitter throttle/brake lever
• Put the reverse switch for steering or the drive at the transmitter in the right position.
• If the brushless motor is disconnected from the speed controller and reconnected, the alignment of the three connection
cables is not correct (this may not be possible with this vehicle, because there is no plug connection between the
motor and the speed controller). Simply swap two of the three cables between motor and speed controller. This will
reverse the rotational direction of the brushless motor.
The steering is not functioning or is functioning incorrectly, steering lock too slight on the vehicle
• If the transmitter offers dual rate settings, check these settings (observe transmitter's operating instructions). If the
dual rate setting is too low, the steering servo will no longer react.
• Check the steering mechanics for loose parts; e.g. check if the servo arm is properly attached to the servo.
After switching on of the speed controller, the motor only emits sound signals but the drive does not work
• The battery voltage is too high or too low Switch off the speed controller and connect a fully charged driving battery.
Please note: Only connect either a 6-cell NiMH-battery (nominal voltage 7.2V) or a 2-cell LiPo-battery (nominal
voltage 7.4V) to the speed controller!
• The receiver's signal is faulty. Check the cable connection between the speed controller and receiver. Check the
transmitter's function (are the batteries/rechargeable batteries empty? Are the right crystals inserted in the transmitter
and receiver?).
60