Materials Used - Dräger Evita 2 dura Instructions For Use Manual

Technical Data

Materials used

Cable length
Load impedance
Signal level (at load impedance 3000 to 7000 Ω)
Low
High
Electrical isolation
Pin assignment
Digital output
Digital output (optional)
Digital output (optional)
Analogue output (optional)
Electromagnetic compatibility (EMC)
(conforming to European Directive 89/336/EEC)
Classification
as per EC Directive 93/42/EEC Annex IX
UMDNS-Code
Universal Medical Device Nomenclature System –
Nomenclature for medical products
Materials used
Part
Ventilation hose
Water traps
Y-piece
with
connector for temperature measurement
Expiration valve
housing, closure
Diaphragm
CO
cuvette
2
Temperature sensor/cable
CO sensor/cable
2
114
Up to 15 m
3000 to 7000 Ω
Between 3 and 15 V
Between –3 and –15 V
Port COM 1 is electrically isolated from the machine
electronics.
The test voltage for the electrical isolation equals 1500 V.
Pin 2
Pin 3
Pin 5
Connector housing
Output for independent lung ventilation (ILV)
for output and reception via two RS 232 C interfaces
for output and reception via a CAN interface
for output of analog data
Tested in accordance with EN 60601-1-2
II b
17-429
Appearance
milky, transparent
yellow, transparent
milky, transparent
yellow, transparent
white
whitish and grey
yellow, transparent
milky/green or blue
grey/grey
RxD
TxD
GND
Machine housing
Material
silicone rubber
polysulphone
polysulphone
silicone rubber
polyamide
silicone rubber and aluminium
polysulphone with glass windows
silicone rubber
polyurethane