Ndis 3.0 Miniport Driver Error Messages - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

NDIS 3.0 Miniport Driver Error Messages

For each error message below the first line contains the error code used by
Windows 95. The second line contains the "Event ID" and "Data" fields used by
Windows NT.
Code Description
1388 Resource Conflict
5000 OCE3XM1: Has encountered a conflict in resources and could not load.
Action: Check the resources used by the network adapter(s) to ensure, that no conflicts exists.
1389 Out of Resources
5001 OCE3XM1: Could not allocate the resources necessary for operation
Action: The driver failed to load, because it tried to allocate too many resources.
138A Hardware Failure
5002 OCE3XM1: Has determined that the adapter is not functioning properly.
Action: The adapter could not be found or is not working properly. Check I/O base settings and retry the
operation.
138B Adapter Not Found
5003 OCE3XM1: Could not find an adapter.
Action: The adapter could not be found by the MAC driver. Check I/O base settings and retry the operation.
138C Interrupt Connect
5004 OCE3XM1: Could not connect to the interrupt number supplied.
Action: The interrupt is already used by another device. Change the adapter interrupt number and retry the
operation.
138D Driver Failure
5005 OCE3XM1: Has encountered an internal error and has failed.
Action: An internal error has been discovered. Contact Olicom Technical Support.
138E Bad Version
5006 OCE3XM1: The version number is incorrect for this driver.
Action: The driver version is incorrect. Contact Olicom Technical Support.
138F Time out
5007 OCE3XM1: Timed out during an operation.
Action: A time-out error occurred. Contact Olicom Technical Support.
1390 Network Address
5008 OCE3XM1: Has encountered an invalid network address.
Action: An invalid network address was specified. Change the locally administered network address and
restart your system. The driver uses the burned-in address when loading.
1393 Missing Configuration Parameter
5011 OCE3XM1: A required parameter is missing from the Registry.
Action: A parameter necessary for operation has been omitted in the registry. Use the Network Setup to set
proper parameters.
1396 Adapter Disabled
5014 OCE3XM1: The adapter is disabled. The driver cannot open the adapter.
Action: Make sure the Olicom adapter driver is properly installed. Remove the adapter and install it again
using the method described in this help file.See also the troubleshooting section for further information on
how to enable the adapter.
1397 I/O Port Conflict
5015 OCE3XM1: There is an I/O port conflict.
Action: The ports used by the MAC driver is already in use by another device. Change the I/O address for
the adapter.
139A Interrupt Conflict
5018 OCE3XM1: There is a interrupt conflict at interrupt number XX.
Action: Change the interrupt selection on the adapter and re-try the operation.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
67
Driver Messages