Olicom Ethernet MCA 10/100 Adapter Manual To Operations page 38

The following parameters may be set with the OCE3XODI driver:
PORT
The I/O base for the adapter.
In the majority of cases there is no need to specify this parameter as the driver
will search for an adapter at all valid I/O bases.
However, if you have installed two or more adapters on the same machine, you
must specify this parameter in every LINK DRIVER OCE3XODI entry in
NET.CFG.
Possible values for the Ethernet MCA 10/100 Adapter are: 200, 240, 280, 2C0,
300, 340, 380, 3C0 (Hex).
SPEED (Auto, 10, 100)
This parameter can be used to force the Ethernet MCA 10/100 Adapter to use a
specified data rate of either 10 Mbps or 100 Mbps. If "Auto" is selected
(parameter omitted or zero) the Ethernet MCA 10/100 Adapter will auto-
negotiate the speed and use the highest possible value.
DUPLEX (AUTO, HALF, FULL)
This parameter can be used to force the Ethernet MCA 10/100 Adapter into a
specified duplex mode, that is full or half duplex. If "AUTO" is selected
(parameter omitted or zero) the Ethernet MCA 10/100 Adapter will auto-
negotiate the duplex mode and use the best possible value.
In some hubs and switches the auto-negotiation of duplex operation is
unresolved. In such cases half duplex operation will be used. If full duplex
operation is required, use "Full" to force this mode.
NODE
Enter this parameter only if you want to manually administer node addresses in
your installation. If not entered, the on-board, globally-assigned address
(Burned-in Address) is used.
If an address is entered, the 11th digit from the right must be 2, 6, A or E as in
02123456789A.
FRAME
The media frame type parameter determines the Ethernet packet header(s) that
the driver will support.
Supported values for this parameter are:
Ethernet_802.2
Ethernet_802.3
Ethernet_II
Ethernet_SNAP
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
31
Software Installation