Ibm Dos Environment; Ibm Lan Support Program (Dos); Ibm Dos Lan Services - Dls - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

40

IBM DOS Environment

IBM LAN Support Program (DOS)

This section describes the procedure for installing the Olicom NDIS 2.0 MAC
driver in the IBM LAN Support Program for DOS with the IBM Installation Aid.
1. Follow the guidelines described by IBM for " Installing the LAN Support
Program " with the " Installation Aid " program.
2. Run the Installation Aid program:
DXMAID
3. When prompted for changes in the "Setup" window, select "YES" in the field
labelled "Do you have Driver Diskettes?".
4. When the "Process Driver Diskette" window appears, insert the Olicom Driver
Disk and type:
A:\IBM\NDIS.DOS
5. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" in the "ADAPTER
DRIVER" window.
6. Press F5 to change or view the NDIS driver parameters.
For more information about parameters which may be used for configuring the
network adapter, see the Olicom online documentation for detailed
information.
7. Follow the IBM guidelines to complete the installation.
The MAC driver for the adapter is now installed in the LAN Support Program
configuration. To install the IBM DOS LAN Requester, follow the guidelines
given by IBM.

IBM DOS LAN Services - DLS

The adapter driver can be installed either during DOS LAN Services installation or
after DOS LAN Services has been successfully installed. The installation
described below covers DOS LAN Services versions 4.0 and 5.0.
Driver Installation during DOS LAN Services Installation
1. Start the installation as described by IBM with the following command:
A:\INSTALL
2. When prompted for the type of network card used, select "Network card not
shown in list below" and press Enter to continue.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation