Microsoft Network Client 3.0 For Dos - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

28

Microsoft Network Client 3.0 for DOS

This section describes how to install the NDIS 2.0 MAC driver with Microsoft
Network Client v. 3.0 for MS-DOS.
1. Run the Microsoft Network Client "SETUP" program either from the
installation disk or from the \NET directory on your hard disk.
2. When you are prompted to select a network adapter, choose "Network adapter
not shown on list below ..." if your Olicom adapter is not contained in the list.
3. Insert the Olicom Driver Disk (and change the path to "A:\" if necessary).
4. Press Enter and select the Olicom adapter.
5. Follow the instructions from the Microsoft Network Client SETUP program to
complete the installation.
For additional information about adapter configuration parameters, see
Configuring the NDIS 2.0 MAC Driver in the Olicom online documentation.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation