Olicom Ethernet MCA 10/100 Adapter Manual To Operations page 48

3. Insert the Olicom Driver Disk into drive "A" and specify the location of the
OEMSETUP.INF file to be:
A:\IBM\NDIS.DOS
4. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" and change if
required the default settings by selecting "Edit settings for network card
driver".
5. Select "Driver configuration is correct" and press Enter to continue.
6. Follow the guidelines given by IBM to proceed with the installation.
7. When the "Installation Complete" screen appears, press F3 for Exit without
rebooting.
8. Copy the driver from the Olicom Driver Disk to your default DOS LAN
Services (for example C:\NET) directory by inserting the Olicom Driver Disk
into drive "A" and entering the following command:
COPY A:\IBM\NDIS.DOS\OCE3XND2.DOS C:\NET
9. Reboot your PC to start DOS LAN Services.
Driver Installation after DOS LAN Services Installation
1. Start the installation as described by IBM with the following command:
C:\NET\INSTALL
2. Select "The listed options are correct" and press Enter to continue.
3. Select "Network Card" and press Enter to continue.
4. Select "Change driver for network card" and press Enter to continue.
5. Select "Network card not shown in list below" and press Enter to continue.
6. Insert the Olicom Driver Disk into drive "A" and specify the location of the
OEMSETUP.INF file to be
A:\IBM\NDIS.DOS
7. Press Enter to continue.
8. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" and change - if
required - the default settings by selecting "Edit settings for network card
driver".
9. Select "Driver configuration is correct" and press Enter to continue.
10. Follow the guidelines given by IBM to complete the installation.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
41
Software Installation