Windows Nt 3.5X - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

22

Windows NT 3.5x

Adapter Installation during Windows NT Installation
1. Install the Ethernet MCA 10/100 Adapter in a free expansion slot as described
in chapter 3.
2. Follow the instructions in the Windows NT System Guide to begin Windows
NT installation.
3. If you have selected custom set-up, select "Do Not Detect" when the "Network
Adapter Card Detection" window displays.
4. When the message "Setup did not detect a network card" displays, select
"Continue" to go to the adapter card setup phase.
5. Continue with step 5 in the "Adapter Installation after Windows NT
Installation" section below.
Adapter Installation after Windows NT Installation
If you are installing a network adapter after Windows NT has been successfully
installed on the system, you must be logged on with administrative rights to be
able to add, configure and remove adapters.
1. Install the Ethernet MCA 10/100 Adapter in a free expansion slot as described
in chapter 3.
2. Select the Control Panel in the Main window.
3. Select the Network icon.
4. In the Network Settings panel, select the "Add adapter" button.
5. In the list of Network Adapter Cards, select "<Other> Requires disk from
manufacturer" and press the "Continue" button.
6. Enter the full path to the setup files. When installing from the Olicom Driver
Disk enter:
A:\
7. Select the correct adapter type and press the "OK" button. The setup program
now copies installation files to the hard disk.
8. Review the binding settings by selecting the "Bindings" button. Press "OK" to
return from the Network Bindings window.
9. Select the "OK" button in the Network control panel when all adapters have
been added.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation