Table of Contents
Advertisement
20
Microsoft Windows NT
The adapter driver installation procedure for Microsoft Windows NT Workstation
is identical to that of Microsoft Windows NT Server. In the following, both will be
referred to as Windows NT. The installation procedure is however different for
versions 3.5x and 4.0 of Windows NT. Before you begin the installation process,
review the "Configuring the Network" section in the Windows NT System Guide.
The NDIS 3.0 Miniport driver installation procedure described below will copy all
necessary set-up files to the Windows NT "System32" directory and the driver to
the"System32\Drivers" directory. In addition, several changes will be made to the
system registry. Do not attempt to edit the registry manually; all driver parameters
can be set from the network section of the control panel.
Installation Procedure
The installation procedure allows installation either during the initial Windows NT
installation or after Windows NT has been successfully installed on the system. If
you are running Windows NT 4.0, proceed to the Windows NT 4.0 section. If you
are running Windows NT 3.5x, proceed to the Windows NT 3.5x section.
Windows NT 4.0
Adapter Installation during Windows NT Installation
1. Install the Ethernet MCA 10/100 Adapter in a free expansion slot as described
in chapter 3.
2. Follow the instructions in the Windows NT System Guide to begin the
Windows NT 4.0 installation process.
3. If you have chosen custom setup, do not start the adapter search in the
"Network Setup Wizard" dialog box. Choose instead "Select from list".
4. Click the "Have Disk..." button and enter the full path to the Olicom setup
files. If you are installing from the Olicom Driver Disk, enter:
A:\
5. Select the correct adapter type and press the "OK" button.
6. Click the "Next" button when all adapters have been added.
7. Follow the Network Setup Wizard to choose appropriate Protocols and
Services to continue the installation. You will be prompted twice for the path to
your NT installation files. First enter the path to the NT installation files (for
example the Windows NT CD-ROM) and secondly enter the path to the
Olicom setup files (same path as entered under step 4).
8. Follow the Network Setup Wizard to finish the installation.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
Software Installation
Advertisement
Table of Contents
Troubleshooting
