Ibm Mpts - Lan Server 4.0/5.0, Os/2 Warp - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

44
Install the MAC Driver after Installation of LAPS
1. Make \IBMCOM the current directory and run the LAPS program by typing:
CD \IBMCOM
LAPS
2. Select the "Install" option in the LAPS main menu.
3. When prompted for the source path of "Additional Network Drivers", insert the
Olicom Driver Disk, enter the path "A:\IBM\NDIS.OS2" and select "OK".
4. When the message "Installation Complete" appears on screen, select "OK".
Configuration of the Ethernet adapter can now take place.
5. Select "Configure", "Configure LAN Transport" and "Continue".
6. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" as the network
adapter by adding it to "Current Configuration".
The parameters of the Olicom adapter may now be edited.
7. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" in the current
configuration list and then "Edit".
Note: If you have more than one Ethernet MCA Adapter in your system, you
should set the "I/O Address" parameter for "Olicom Ethernet MCA 10/100
Adapter (OC-2335)".
8. Add and configure protocols to suit the requirements.
9. Select "OK" when the configuration of the LAN Transports is complete.
10. Select "Exit" in the LAPS main menu and let LAPS update CONFIG.SYS on
the boot drive by selecting "Continue".
11. Follow instructions given by LAPS to complete the installation.

IBM MPTS - LAN Server 4.0/5.0, OS/2 WARP

You may choose between driver installation during MPTS (Multi-Protocol
Transport Services) installation or after MPTS installation.
MAC Driver Installation during MPTS Installation
1. Install MPTS as described by IBM.
2. At a point during the installation the MPTS main menu will appear again, but
with the "Exit", "Configure", "Install", "Remove", and "Help" options
selectable.
3. Proceed with the installation as described in step 2 under "Driver Installation
after MPTS Installation".
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation