Microsoft Windows 95; Multiple Adapter Configuration - Windows 95; Adapter Parameters - Olicom Ethernet MCA 10/100 Adapter Manual To Operations

18

Microsoft Windows 95

1. Install the Ethernet MCA 10/100 Adapter in a free expansion slot and connect
the cable between the adapter and the network as described in chapter 3.
2. Start Windows 95.
3. Select "Settings" and "Control Panel" from the Windows 95 "Start Menu".
4. From the "Control Panel", select "Network".
5. Press "Add" and select "Add Adapter".
6. From the Select Network Adapters window, press "Have Disk", insert the
Olicom Driver disk, and select "Olicom Ethernet MCA 10/100 Adapter
(OC-2335)".
7. Press "OK" to complete the installation.
8. Restart Windows 95 for the changes to take effect.
Note : NetWare Client 32 for Windows 95 is described on page page 32.

Multiple Adapter Configuration - Windows 95

If installing more than one Ethernet MCA 10/100 Adapter in the same computer,
the network driver must be installed once for each network adapter. The first driver
will load on the first adapter, the second driver on the second adapter, and so forth.

Adapter Parameters

To configure the network adapter, open "Network" in the "Control Panel", select
"Olicom Ethernet MCA 10/100 Adapter (OC-2335)" and click the "Properties"
button. Click the "Advanced" tab to set the adapter parameters. The default
parameters will work correctly for most configurations. Use defaults if you do not
know what the parameters do.
LAN Speed (Auto, 10 Mbps, 100 Mbps)
This parameter can be used to force the Ethernet MCA 10/100 Adapter to use a
specified data rate of either 10 Mbps or 100 Mbps. If "Auto" is selected,
the Ethernet MCA 10/100 Adapter will auto-negotiate the speed and use the
highest possible value.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation