Table of Contents
Advertisement
46
Configuring the NDIS 2.0 MAC Driver
Configuration of the NDIS 2.0 MAC driver is described in detail in the Olicom
online documentation, Configuring the NDIS 2.0 MAC Driver .
NDIS 2.0 MAC Driver Messages
When you boot your system, a number of messages is displayed on the screen.
Some messages are for information only and some are information about errors.
During driver load, the following text is displayed:
DOS NDIS 2.02: MAC Driver for Ethernet ISA/MCA 10/100
Adapters vx.xx (xxxxxx)
Copyright 1997, Olicom A/S. All Rights Reserved.
OC-2335 MAC driver installed.
Using I/O address XXX-XXX, IRQ YY
100 Mbps, Half duplex operation detected.
The speed and duplex operation displayed in the last line will vary depending on
the detected mode and/or settings from PROTOCOL.INI.
If messages other than the one above is displayed, a failure is indicated. See the
error message listings in appendix B.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
Software Installation
Advertisement
Table of Contents
Troubleshooting
