Olicom Ethernet MCA 10/100 Adapter Manual To Operations page 52

MAC Driver Installation after MPTS Installation
1. Run the MPTS program. Make \IBMCOM your current directory (by typing
"CD \IBMCOM") and type "MPTS".
2. Select the "Configure" option in the MPTS main menu.
3. Select "LAN Adapters and Protocols" and then "Configure".
Push the "Other Adapters..." button.
4. Insert the Olicom Driver Disk, enter the path "A:\IBM\NDIS.OS2" and press
"OK".
5. Select "Olicom Ethernet MCA 10/100 Adapter (OC-2335)" as your network
adapter card by adding it to the "Current Configuration".
6. Edit the parameters of the Ethernet MCA Adapter by first selecting "Olicom
Ethernet MCA 10/100 Adapter (OC-2335)" in the current configuration list
and then selecting "Edit".
Note: If you have more than one Ethernet MCA Adapter in your system, you
should set the "I/O Address" parameter for "Olicom Ethernet MCA 10/100
Adapter (OC-2335)".
7. Add and configure protocols to suit your requirements.
8. Select "OK" when the configuration of the LAPS configuration complete and
select "Close" to end configuration.
9. Select "Exit" in the MPTS main menu and let MPTS update your
CONFIG.SYS on your boot drive by selecting "Continue".
10. Follow instructions given by MPTS to complete the installation. The Ethernet
Adapter will become active when the system is rebooted.
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414
45
Software Installation