Calculating The Installed Dimensions; C Dimension; D Dimension; A Dimension - Zepro Z 10 Installation Instructions Manual

Calculating the installed dimensions

4 Calculating the installed dimensions
For easier installation, it is useful to calculate and specify the necessary dimensions in advance. Determine
the C dimension first, then obtain the other dimensions from the relevant table. You should try to place the
lift as high as possible within the specified C dimension in the table.
4.1

C dimension

The C dimension is the distance between the top of the support frame and the vehicle floor level. This dimen-
sion governs how far the lift needs to be installed under the vehicle body (D dimension) and the space there will
be between the 1st booms in the upper position and the vehicle floor level (A dimension).
4.2

D dimension

The D dimension is the space the lift needs, measured from the rear edge of the body to the front edge of the
support frame (in the direction of the vehicle). Once the C dimension is determined, the D dimension can be
obtained from the table.
4.3

A dimension

The A dimension is the space provided for the rear member, i.e. the space there will be between the 1st
boom and the vehicle floor with the lift in the raised position. The A dimension depends on the C dimension
4.4

H dimension

The H dimension is the height from the ground (unloaded) to the vehicle floor level. The H dimension must
not be greater than the maximum lifting height of the lift. The platform must always be able to reach ground
level.
12
Z 10/15/20
www.zepro.com