Before Installation; Calculating The Installed Dimensions - Zepro ZHZ 500 Installation Instruction

Before installation

4 Before installation
4.1

Calculating the installed dimensions

For easier installation, it is useful to calculate and specify the necessary dimensions in advance. Determine
the C-dimension first, then obtain the other dimensions from the relevant table. You should try to position the
lift as high as possible within the specified C-dimension in the table.
4.1.1 C-dimension
The C-dimension is the distance between the top the support frame and the vehicle floor level. This dimension
governs how far the lift needs to be installed under the vehicle body (D-dimension) and the space between the
lift arms in the upper position and the vehicle floor level (A-dimension).
4.1.2 D-dimension
The D-dimension is the space that the lift needs, measured from the rear edge of the body to the front edge of
the support frame (in the direction of the vehicle). Once the C-dimension has been determined, the D-dimension
can be obtained from the table.
4.1.3 H-dimension
The H-dimension is the height from ground (unloaded) to the vehicle floor level. The H-dimension must not
be greater than the lift's maximum lifting height. The lift's platform must always be able to reach ground level.
10
ZHZ 500/600-850
ZHZ 500/600-850
C D
450 557
400 597
350 629
300 640
250 674
200 688
150 698
D
C
297
www.zepro.com