Table of Contents
Advertisement
Installation
ZS MK2
5.8
Transport stops
Transport stops must be installed to secure the platform during transport.
IMPORTANT!
Transport stops must always be installed in pairs, one on each slider profile.
1. Run the lift to transport position.
2.
Choose an appropriate hole pattern for installing the transport stop.
3. If necessary, cut the bracket above the mounting (A).
4. Bolt the transport stops to the left and right slider profiles.
Tightening torque: 70-75 Nm.
A
Picture 36. Installing transport stops
www.zepro.com
27
Advertisement
Table of Contents
