Table of Contents
Advertisement
Conettix Universal Dual Path Communicator
7.7.1
Ethernet IP Address / Host Name
Default: blank
Selections:
–
–
Enter an IPv4 address, an IPv6 address, or host name.
The B465 uses this IP address to send reports to the central station receiver over Ethernet
technology.
Further information
IP Address and Domain Name formats
USB Menu Location
[2] Standard Communication Configuration > [4] Primary Receiver > [2] Ethernet IP Address /
Host Name
- or -
[3] Advanced Communication Configuration > [2] Receiver Setup > [1] Primary Receiver > [2]
Ethernet IP Address / Host Name
7.7.2
Port Number
Default: 7700
Selections: 1 to 65,535
This is the port number the B465 uses for communication with the central station receiver.
USB Menu Location
[2] Standard Communication Configuration > [4] Primary Receiver > [1] Port Number
- or -
[3] Advanced Communication Configuration > [2] Receiver Setup > [1] Primary Receiver > [1]
Port Number
7.7.3
Ethernet Supervision Time
Default: 1 hour
Selections:
–
–
–
–
–
–
–
–
The B465 must receive an ACK (acknowledgement) to a heartbeat poll within the time defined
by the Ethernet Supervision Time parameter. To reduce network traffic, the B465 adjusts the
heartbeat poll rate, ACK wait time, and Retry Count to support the Ethernet Supervision Time
you select.
If the B465 does not receive an ACK to a heartbeat poll after the retry count is met, it creates
a Communication Trouble event.
USB Menu Location
[2] Standard Communication Configuration > [4] Primary Receiver > [3] Ethernet Supervision
Time
- or -
Bosch Security Systems, Inc.
IPv4 - 0.0.0.0 to 255.255.255.255
IPv6 - 0000:0000:0000:0000:0000:0000:0000:0000 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
No polling
90 seconds
180 seconds
200 seconds
5 minutes
1 hour
4 hours
24 hours
Installation and Operation Manual
Communication Configuration | en
2017.11 | 05 | F.01U.311.207
61
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
