Download Print this page

Bosch B430 Installation Manual

Plug-in telephone communicator.
Hide thumbs
   

Advertisement

1 | Overview
The B430 connects to the control panel for communication over the PSTN (Public
Switched Telephone Network).
1
1
Callout ― Description
1 ― Module handle and support leg
2 ― Line seize/ring LED
3 ― Test phone pads
2 | Install or remove the module
NOTICE!
Remove all power (AC and battery) before making any connections. Failure to
do so might result in personal injury and/or equipment damage.
2.1 | Install the module
1.
Insert the support leg into the support hole labeled X.
2.
Align the PCB metal contacts with the on-board connector.
3.
Push the module into place until it is tight.
Callout ― Description
1 ― Support leg
2 ― PCB metal contacts
2
3
4
5
6
Callout ― Description
4 ― RJ45 phone connector
5 ― Plug-in module retention clip
opening
6 ― PCB metal contacts
Callout ― Description
3 ― Plug-in module retention clip
2.2 | Wire the module
1.
Connect one end of a telephone
cord to the B430.
2.
Connect the other end to an
RJ31X or RJ38X phone jack. The
module has pads on both sides of
the board to connect a telephone
test set. Refer to the following
illustration.
Callout ― Description
1 ― Premises telephone
2 ― Incoming Telco line
3 ― Installer telephone test set
4 ― RJ45 phone connector
2.3 | Remove the module
1.
Open the retention clip.
2.
Hold the top corners of the support
handle.
3.
Pull out the module.
3 | LED descriptions
Refer to the following table.
Flash pattern
Function
OFF Steady
Standby
ON Steady
Line seize
Flash
Ring detect
4 | Configuration
Use Remote Programming Software
(RPS) or an SDI2 keypad to program.
For programming parameter
descriptions, options, and defaults refer
to RPS Help or the Program Entry Guide
for your control panel.

Advertisement

   Also See for Bosch B430

   Related Manuals for Bosch B430

   Summary of Contents for Bosch B430

  • Page 1

    1 | Overview 2.2 | Wire the module 3 | LED descriptions The B430 connects to the control panel for communication over the PSTN (Public Refer to the following table. Connect one end of a telephone Switched Telephone Network). cord to the B430.

  • Page 2

    Copyright This document is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly.

Comments to this Manuals

Symbols: 0
Latest comments: