PHILIPS Respironics Trilogy 202 User Manual page 162

Control Accuracy
Parameter
IPAP
EPAP
CPAP
PEEP
Pressure
Pressure Support
Tidal Volume
Breath Rate
Timed Inspiration
Rise Time
Ramp Start Pressure
Ramp Length
Flex
Flow Trigger Sensitivity
Flow Cycle
Apnea Rate
FiO 2 Output
O Input Pressure Rating
2
Specifications listed are based on using a standard circuit consisting of 1.8 meter tubing- REF 622038, one of the following exhalation
devices: Whisper Swivel II - REF 332113; Active PAP Exhalation Device - REF 1053716; Active Flow Exhalation Device REF 1049503 or
Active Exhalation Device – REF 1065659 and Trilogy Proximal Flow Sensor- REF 1050408 (if required).
Limited to 25 cmH O when using the Bi-Flex feature in S mode.
1
2
Pressure units may be cm H
2
The difference between the Inspiratory Pressure and the Expiratory Pressure must never be more than 30 cmH
3
Pressure Support and PEEP not to exceed 50 cmH
4
All flows and volumes are measured at BTPS conditions.
5
The range of values correspond to tenths of seconds (e.g., a setting of 4 indicates a Rise Time of 0.4 seconds).
6
Flex is not available when AVAPS is active. Flex is not available with Active Circuits.
7
Range
4 to 50 cmH O
1 2
2
0 to 25 cmH O for Active Circuits
2
4 to 25 cmH O for Passive Circuits
2
4 to 20 cmH O
2
0 to 25 cmH O for Active Circuits
2
4 to 25 cmH O for Passive Circuits
2
4 to 50 cmH O
2
0 to 30 cmH O
3
2
50 to 2000 ml
5
0 to 60 BPM for AC mode
1 to 60 BPM for all other modes
0.3 to 5.0 seconds
1 to 6
6
0 to 25 cmH O for Active Circuits
2
4 to 25 cmH O for Passive Circuits
2
4 to 19 cmH O in CPAP mode
2
Off, 5 to 45 minutes
Off, 1 to 3
7
1 to 9 l/min
10 to 90%
4 to 60 BPM
21% to 100%
40 to 87 PSI
O, hPa, or mBar depending on device setup.
2
O.
2
Accuracy
Greater of 2 cmH O or 8% of setting
2
Greater of 2 cmH O or 8% of setting
2
Greater of 2 cmH O or 8% of setting
2
Greater of 2 cmH O or 8% of setting
2
Greater of 2 cmH O or 8% of setting
2
Greater of 2 cmH O or 8% of setting
2
Greater of 15ml or 10% of setting (Active Circuits)
Greater of 15ml or 15% of setting (Passive Circuits)
Greater of ± 1 BPM or ±10% of the setting
± .1 second
±2 cmH O (the device will increase to a pressure
2
of .67* (IPAP - EPAP) ±2 cmH
multiplied by 100 ms for pressure supports less than
or equal to 25.)
8% of setting + 2% Full Scale
±2 minutes
N/A
N/A
N/A
Greater of 1 BPM or 10% of setting
21% to 50% is ±3%
50% to 95% is ±5%
100% is -5%
N/A
Chapter 11 Technical Specifications
153
4
4
O @ the set rise time
2
O.
2