Toyota Highlander 2020 Owner's Manual page 384

384
5-5. Using the other interior features
ble device. (To check device
compatibility, refer to
www.homelink.com.)
1
Within 5 seconds after pro-
gramming the garage door
opener has been completed,
if the garage door opener
motor is trained to Home-
®
Link , both garage door
operation indicators will flash
rapidly (green) and the light
on the garage door opener
motor will blink twice, indicat-
ing that 2-way communica-
tion is enabled.
If the indicators do not flash, per-
2 3
form and within the first 10
presses of the HomeLink
after programming has been com-
pleted.
2
Press a programmed Home-
®
Link button to operate a
garage door.
3
Within 1 minute of pressing
the HomeLink
the garage door operation
has stopped, press the
"Learn" or "Smart" button on
the garage door opener
motor. Within 5 seconds of
the establishment of 2-way
communication with the
garage door opener, both
garage door operation indica-
tors in the vehicle will flash
rapidly (green) and the light
on the garage door opener
motor will blink twice, indicat-
HIGHLANDER_U
■
When the following procedure is
performed, buttons which
already have devices registered
to them can be overwritten:
1
2
®
button
■
●
●
®
button, after
Press the appropriate Home-
Link
indicator light should turn on.
The status of the opening and
closing of a garage door is
shown by the garage door
opener indicators.
ing that 2-way communica-
tion is enabled.
Reprogramming a single
®
HomeLink button
Press and hold the desired
®
HomeLink button.
When the HomeLink
tor starts flashing orange,
release the HomeLink
ton and perform "Program-
®
ming HomeLink "
20 seconds for the Home-
®
Link indicator to start flash-
ing).
Before programming
Install a new battery in the trans-
mitter.
The battery side of the transmitter
must be pointed away from the
®
HomeLink buttons.
Operating HomeLink
®
button. The HomeLink
®
indica-
®
but-
1
(it takes
®
®