Toyota Highlander 2020 Owner's Manual page 309

Hide thumbs Also See for Highlander 2020:
Table of Contents

Advertisement

Dynamic Torque Vectoring
AWD vehicles
1
Mud & Sand mode
When the switch is turned to the left
while not in Mud & Sand mode, the
system switches to Mud & Sand
mode and the Mud & Sand mode
indicator, VSC OFF indicator and
PCS warning light illuminate on the
multi-information display.
2
Normal mode
Mode that performs AWD, brake
and drive force control suitable for
driving on general roads. Use nor-
mal mode when not driving
off-road.
The driving mode returns to normal
mode if the switch is pressed while
in Mud & Sand mode or Rock & Dirt
mode.
3
Rock & Dirt mode
When the switch is turned to the
right while not in Rock & Dirt mode,
the system switches to Rock & Dirt
mode and the Rock & Dirt mode
indicator illuminates on the
multi-information display.
Multi-terrain Select
Multi-terrain Select is intended for
use when driving on rough roads.
Drive in normal mode during nor-
mal driving.
The Mud & Sand and Rock & Dirt
HIGHLANDER_U
4-5. Using the driving support systems
modes control the vehicle so that
it can maximize the drive force
and improve drivability on rough
roads. As a result, fuel efficiency
may diminish when compared to
driving in normal mode.
If Mud & Sand or Rock & Dirt
mode is selected
The background of the multi-infor-
mation display will change follow-
ing the Multi-terrain Select mode.
The AWD operation status display
will automatically switch on the
multi-information display.
AWD control for Mud & Sand
and Rock & Dirt modes
If the vehicle speed exceeds the
speeds listed below, AWD control is
performed similar to that performed
in Normal mode, even if Mud &
Sand or Rock & Dirt mode is
selected.
Mud & Sand mode: Vehicle speed
is approximately 25 mph (40
km/h) or more
Rock & Dirt mode: Vehicle speed
is approximately 16 mph (25
km/h) or more
If the vehicle speed drops below the
above speeds, the system automati-
cally switches to the AWD control
suitable for each mode.
When Multi-terrain Select brake
control temporarily stops oper-
ating
If Mud & Sand or Rock & Dirt mode
is continuously used for a long
period of time, the brakes may over-
heat, and Multi-terrain Select brake
control may temporarily stop operat-
ing.
At this time, the buzzer sounds
intermittently and "Traction Con-
trol Turned OFF" is displayed on
the multi-information display.
If Multi-terrain Select brake control
stops operating, stop the vehicle
in a safe location as soon as pos-
*
sible
and wait until the system
309
4

Advertisement

Table of Contents
loading

Table of Contents