Toyota Highlander 2020 Owner's Manual page 285

Hide thumbs Also See for Highlander 2020:
Table of Contents

Advertisement

multi-information display. (Each
time the engine switch is turned off
then changed to ON, the RCTA
function will be enabled automati-
cally.)
WARNING
Cautions regarding the use of
the function
The driver is solely responsible for
safe driving. Always drive safely,
taking care to observe your sur-
roundings.
The RCTA function is only a sup-
plementary function which alerts
the driver that a vehicle is
approaching from the right or left
at the rear of the vehicle. As the
RCTA function may not function
correctly under certain condi-
tions, the driver's own visual con-
firmation of safety is necessary.
Over reliance on this function may
lead to an accident resulting
death or serious injury.
NOTICE
Before using the RCTA func-
tion
Do not place objects near the sen-
sors.
Outside rear view mirror indica-
tor visibility
In strong sunlight, the outside rear
view mirror indicator may be difficult
to see.
Hearing the RCTA buzzer
The RCTA buzzer may be difficult to
hear over loud noises, such as if the
audio system volume is high.
When "Rear Cross Traffic Alert
Unavailable" is shown on the
multi-information display
Water, ice, snow, mud, etc., may be
attached to the rear bumper around
HIGHLANDER_U
4-5. Using the driving support systems
the sensors. (P.272) Removing
the water, ice, snow, mud, etc., from
the attached to the rear bumper
around the sensors to return the
function to normal.
Additionally, the function may not
operate normally when driving in
extremely hot or cold environments.
Rear side radar sensors
P.272
Setting the buzzer volume
Adjusting the buzzer vol-
ume
The buzzer volume can be
adjusted on the multi-informa-
tion display.
4.2-inch display
Use the meter control switches
to change settings. (P.87)
1
Press
2
Press
"RCTA" and then press and
hold
3
Select the volume and then
press
Each time the switch is pressed,
the volume level will change
between 1, 2, and 3.
7-inch display
Use the meter control switches
to change settings. (P.96)
1
Press
2
Press
"RCTA" then press and hold
.
285
or
to select
or
to select
.
.
or
to select
or
to select and
4
.
.

Advertisement

Table of Contents
loading

Table of Contents