Toyota Highlander 2020 Owner's Manual page 275

Hide thumbs Also See for Highlander 2020:
Table of Contents

Advertisement

tional when all of the following con-
ditions are met:
The Blind Spot Monitor is on.
The shift lever is in a position
other than R.
The vehicle speed is greater than
approximately 10 mph (16 km/h).
The Blind Spot Monitor will
detect a vehicle when
The Blind Spot Monitor will detect a
vehicle present in the detection area
in the following situations:
A vehicle in an adjacent lane over-
takes your vehicle.
You overtake a vehicle in an adja-
cent lane slowly.
Another vehicle enters the detec-
tion area when it changes lanes.
Conditions under which the
Blind Spot Monitor will not
detect a vehicle
The Blind Spot Monitor is not
designed to detect the following
types of vehicles and/or objects:
Small motorcycles, bicycles,
pedestrians, etc.
Vehicles traveling in the opposite
direction
Guardrails, walls, signs, parked
vehicles and similar stationary
*
objects
Following vehicles that are in the
*
same lane
Vehicles traveling 2 lanes away
from your vehicle
Vehicles which are being over-
taken rapidly by your vehicle
*
: Depending on the conditions,
detection of a vehicle and/or
object may occur.
Conditions under which the
Blind Spot Monitor may not
function correctly
The Blind Spot Monitor may not
HIGHLANDER_U
4-5. Using the driving support systems
• When the sensor is misaligned
• When mud, snow, ice, a sticker,
• When driving on a road surface
• When multiple vehicles are
• When the distance between your
• When there is a significant differ-
• When the difference in speed
• When a vehicle enters a detection
• As your vehicle starts from a stop,
*
• When driving up and down con-
• When driving on roads with sharp
• When vehicle lanes are wide, or
*
• When towing a trailer
• When an accessory (such as a
*
• When there is a significant differ-
• Immediately after the Blind Spot
detect vehicles correctly in the fol-
lowing situations:
due to a strong impact to the sen-
sor or its surrounding area
etc. is covering the sensor or sur-
rounding area on the rear bumper
that is wet with standing water
during bad weather, such as
heavy rain, snow, or fog
approaching with only a small gap
between each vehicle
vehicle and a following vehicle is
short
ence in speed between your vehi-
cle and the vehicle that enters the
detection area
between your vehicle and another
vehicle is changing
area traveling at about the same
speed as your vehicle
a vehicle remains in the detection
area
secutive steep inclines, such as
hills, dips in the road, etc.
bends, consecutive curves, or
uneven surfaces
when driving on the edge of a
lane, and the vehicle in an adja-
cent lane is far away from your
vehicle
bicycle carrier) is installed to the
rear of the vehicle
ence in height between your vehi-
cle and the vehicle that enters the
detection area
Monitor is turned on
Instances of the Blind Spot Moni-
tor unnecessarily detecting a vehi-
275
4

Advertisement

Table of Contents
loading

Table of Contents