5
Installation > Paper Deck Double Deeding Detection Kit-A1 Installation Procedure > Installing the Double Feeding Sensor Unit
Installing the Double Feeding Sensor Unit
1
1) Remove six screws, and then remove the paper deck rear left cover.
x6
3
3) Connect the 7-pin connector of the supplied double feeding sensor harness to the connector CN5
on the deck driver PCB.
5
Installation > Paper Deck Double Deeding Detection Kit-A1 Installation Procedure > Installing the Double Feeding Sensor Unit
2
2) Remove two screws, and then remove the PCB cover.
F-5-93
F-5-93
4
4) Open the four clamps of the harness guide and three clamps.
F-5-95
F-5-95
x2
F-5-94
F-5-94
F-5-96
F-5-96
38
38