Installation > Installation Procedure > Checking and Adjusting the Tilt
Checking and Adjusting the Tilt
MEMO:
The paper deck can tilt depending on the installation site floor condition, resulting in
stepped surfaces of deck covers.
If the step is large, make adjustments following the procedure below.
2
2) If the paper deck is tilted to the left, make adjustments by loosening the right front caster or tightening the right rear caster after loosening the upper nut.
MEMO:
If the step size is about 2 mm, loosen or tighten the caster to change its height by about 4 mm to flatten out the step.
5
Installation > Installation Procedure > Checking and Adjusting the Tilt
Tilt to left
Step
Step
Tilt to right
F-5-77
F-5-77
1
1) By removing a screw, remove the wrench from the inside of the deck left front cover.