Training Courses; Delivery Conditions; Inspection, Transport And Storage - Bender ISOMETER isoEV425 Manual

Important information

1.3 Training courses

Bender is happy to provide training regarding the use of test equipment.
The dates of training courses and workshops can be found on the Internet at
www.bender-de.com -> Know-how -> Seminars.

1.4 Delivery conditions

Bender sale and delivery conditions apply. For software products, the "Soft-
wareklausel zur Überlassung von Standard-Software als Teil von Lieferungen,
Ergänzung und Änderung der Allgemeinen Lieferbedingungen für Erzeug-
nisse und Leistungen der Elektroindustrie" (software clause in respect of the
licensing of standard software as part of deliveries, modifications and changes
to general delivery conditions for products and services in the electrical indus-
try) set out by the ZVEI (Zentralverband Elektrotechnik- und Elektronikindus-
trie e.V.) (German Electrical and Electronic Manufacturers' Association) also
applies.
Sale and delivery conditions can be obtained from Bender in printed or elec-
tronic format.

1.5 Inspection, transport and storage

Inspect the dispatch and equipment packaging for damage, and compare the
contents of the package with the delivery documents. In the event of damage
in transit, please contact Bender immediately.
The devices must only be stored in areas where they are protected from dust,
damp, and spray and dripping water, and in which the specified storage tem-
peratures can be ensured.
isoEV425_D00126_09_M_XXEN/03.2019 9