Connecting The Probe; Introduction - GE LOGIQ V2 User Manual

Getting Started

Introduction

Connecting the Probe

CAUTION
CAUTION
CAUTION
CAUTION
1-54
Only use approved probes.
Inspect the probe before and after each use for damage or
degradation to the housing, strain relief, lens, seal, cable and
connector. DO NOT use a transducer which appears damaged
until functional and safe performance is verified. A thorough
inspection should be conducted during the cleaning process.
Remove any dust or foam rests from the probe pins.
Fault conditions can result in electric shock hazard. Do not
touch the surface of probe connectors which are exposed
when the probe is removed. Do not touch the patient when
connecting or disconnecting a probe.
Probes can be connected at any time, regardless of whether the
console is powered on or off.
To connect a probe:
1. Place the probe's carrying case on a stable surface and
open the case.
2. Carefully remove the probe and unwrap the probe cord.
DO NOT allow the probe head to hang free. Impact to the
probe head could result in irreparable damage.
Probes
LOGIQ V2/LOGIQ V1
Direction 5610736-100 Rev. 9
–
User Guide