Detaching The Cda Motor Assembly - Micron Spraydome Series Instruction Manual

56

9.4.3 Detaching the CDA Motor Assembly

Drum Type Atomiser
The following procedure describes the detaching of the drum type atomiser motor
assembly. To fully remove the motor assembly from the Spraydome/Undavina
disconnect the electrical wires as described in section 9.4.2.
 Remove the motor assembly, retained by three self tapping screws.
 Pull the atomiser drum off the motor shaft. The atomiser drum is a tight
(interference) fit to the motor shaft. Do not use tools to lever the atomiser drum
off the motor spindle as this will damage the atomiser drum.
Disc Type Atomiser
 Instructions for the detaching of the disc type atomiser motor assembly and
atomiser can be found in section 0 of this document.
 To fully remove the motor assembly from the Spraydome/Undavina disconnect
the electrical wires as described in section 9.4.2.
Refitting of the motor assembly is a reversal of the above procedure. Ensure all
components are clean before refitting.
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
Maintenance