Electrical Connections (Cda Units Only) - Micron Spraydome Series Instruction Manual

3.5

Electrical Connections (CDA units only)

 Connect the two pin electrical socket to the Inline plug on the controller backplate
(1). Mount the in line switch (2) in a location where it can be easily used by the
operator. Ensure that the switch position and cable location do not impair access
to, or in any way restrict or impair, the use of any of the vehicles controls.
 Route the cable from the Inline switch (2) to the vehicles battery or a suitable
power outlet.
 With the Inline switch in the off position. Connect the red wire to the positive (+)
terminal and the black wire to the negative (-) terminal.
 If you have installed a Micron tank system connect the two pin electrical socket on
the controller backplate (1) to the two pin plug on the tank system. A cable
assembly with pre wired connectors is available from Micron Group or their
agents.
 To connect to a third party pump. Connect the two pin electrical socket on the
controller backplate (1) to a 10A automotive two core cable using a two pin
electrical plug available from Micron Group.
 Route the cable through the vehicle to the location of your pump.
 Ensure that the cable location does not impair access to, or in any way restrict or
impair, the use of any of the vehicles controls.
Installation
3
2
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
2
1
1
25