Micron Spraydome Series Instruction Manual page 49

 Using a small screwdriver carefully prise the sealing ring out of the bayonet cap.
Take care to avoid damaging the seal. Not applicable where a brass nozzle body
is fitted.
 Inspect the seal for any damage. If the seal is marked or damaged or has become
hard or cracked it should be replaced. Not applicable where a brass nozzle body
is fitted.
 The nozzle tip is a sliding fit into the bayonet cap / brass retaining nut. Turn the
bayonet cap / brass retaining nut over with the open end downwards and the
nozzle should fall out.
 To clean the nozzle tip use a soft bristled brush or toothpick do not use a metal
object or wire brush. Use extreme care with soft tip materials such as plastic as
even a wooden toothpick may distort the orifice.
Refitting of the nozzle is a reversal of the above procedure. Ensure all components
are clean before refitting. Do not over tighten brass retaining nut as this may damage
the nozzle.
Maintenance
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
49