Removing The Disc Type Atomiser - Micron Spraydome Series Instruction Manual

9.3.2 Removing the Disc Type Atomiser

The following procedure describes the removal of the motor assembly and atomiser
disc for the disc type atomiser.
 Follow the procedure for removing the feed nozzle in section 9.2.2.
 Remove the motor assembly; retained by two self tapping screws.
 Move the motor assembly to one side to gain access to the atomiser disc.
 Hold the atomiser disc and turn the retaining screw anticlockwise half a turn. The
atomiser disc will slide easily off the motor shaft.
 When refitting the atomiser disc turn the training screw clockwise to its stop and
then turn it anticlockwise half a turn. The atomiser disc will slide easily onto the
motor shaft. Turn the retaining screw clockwise half a turn and then push the
atomiser disc onto the motor shaft to ensure it is fully home. Check that the
atomiser spins freely.
Maintenance
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
53