Cda Atomisers; Removing The Recirculation Cap And Drum Type Atomiser - Micron Spraydome Series Instruction Manual

52
9.3

CDA Atomisers

9.3.1 Removing the Recirculation Cap and Drum Type Atomiser

The following procedure describes the removal of the recirculation cap and atomiser
drum for the drum type atomiser; on Spraymiser units the atomiser assembly must
first be removed from the shield refer to section 9.3.3.
 Follow the procedure for removing the feed nozzle in section 9.2.1.
 Remove the recirculation cap; retained by two self tapping screws.
 Pull the atomiser drum off the motor shaft. The atomiser drum is a tight
(interference) fit to the motor shaft. Do not use tools to lever the atomiser drum
off the motor spindle as this will damage the atomiser drum.
Refitting of the atomiser drum and recirculation cap is a reversal of the above
procedure. Ensure all components are clean before refitting.
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
Maintenance