Atomiser Motor; Atomiser Motor (Spraymiser); Atomiser Motor (Spraydome/Undavina) - Micron Spraydome Series Instruction Manual

9.4

Atomiser Motor

The atomiser motor can be removed from the atomiser housing for servicing or
replacement without disconnecting the electrical wires from the main assembly. To
disconnect the electrical wire refer to the motor wiring section of this document.

9.4.1 Atomiser Motor (Spraymiser)

Follow the procedure in section 9.3.3 to remove the atomiser assembly and continue
on to section 9.4.3.

9.4.2 Atomiser Motor (Spraydome/Undavina)

The atomiser motor wiring is connected to a screw terminal block under the pivot arm
cover. Only disconnect the atomiser motor wiring when replacing the entire motor
assembly or motor wiring.
 Spraydome/ Undavina Remove the pivot arm cover; retained by three self tapping
screws.
 The motor is wired into a screw terminal block. The, black, negative (-) wire is
connected to the, black, negative (-) wire from the control unit. The, red, positive
(+) is connected to the, red, positive (+) wire from the control unit. Do not connect
the atomiser motor to the, grey, solenoid wire. Refer to section 9.4.4 for further
instruction on wiring the motor.
Maintenance
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
55