Installation; Initial Assembly (Spraydome/Undavina) - Micron Spraydome Series Instruction Manual

3 INSTALLATION

Notes for CDA Installation
The Spraydome/Undavina/Spraymiser CDA Controller has been designed to be
integrated into your tank and spray pump systems. The controller backplate will be
connected to your spray pump and control the on/off operation of the pump. Your
tank system should be regulated to an output pressure of 8 to 10 psi. Your tank
system must include an inline filter of 50 mesh size (blue – ISO19732).
Notes for Hi-Flo Installation
The Hi-Flo spray heads are fitted with traditional hydraulic pressure nozzles and will
easily integrate with most tank systems. Output rates for traditional hydraulic
pressure nozzles depend upon the size of the nozzle and the spray line pressure.
Ensure that your spray tank and pump system are capable of maintaining the
required output flow rate and pressure. Micron Hi-Flo systems will normally operate
at between 1 and 2 bar (15 to 30 psi). Your tank system must include an inline filter
of 50 mesh size (blue – ISO19732).
3.1

Initial Assembly (Spraydome/Undavina)

1
1 Shield, Spray-Head and
Breakaway Assembly
2 Mounting Bracket
Figure 3 - Components for initial assembly of Spraydome/Undavina
Installation
3
2
4
3 Vertical
Support Bar
4 Nyloc Nut
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
6
5
5 Clamp Nut
6 Thick
Washer
19
8
7
7 Thin Washer
8 Clamp Bolt