Mounting To A Tractor; Tank System - Micron Spraydome Series Instruction Manual

24
3.3

Mounting to a Tractor

Spraydome /Undavina
Micron Sprayers Ltd. recommends mounting the Spraydome/Undavina to your tractor
at a point just behind the front wheel. Ensure that the Spraydome/Undavina can be
easily seen from the operator's position. Ensure that there is sufficient space for the
breakaway to operate fully and that the operator's access to the vehicle is not
impaired. Modify the 'T'-bar support tube or fabricate a suitable alternative to fit your
tractor. For further advice on fitting the Spraydome/Undavina contact Micron
Sprayers Ltd. or their agent.
Spraymiser
Micron Sprayers Ltd. recommends mounting the Spraymiser to the rear 3 point
linkage of the tractor, or to the rear of a suitable mounted or trailed tank system. Weld
on vertical clamping tubes and clamp bolts are available from Micron Sprayers Ltd. or
their agents. For further advice on fitting the Spraymiser contact Micron Sprayers Ltd.
or their agent.
Figure 5 - Spraydome/Undavina installation to tractor
When the Spraydome/Undavina or Spraymiser is suitably mounted, fit the controller
backplate support bracket (CDA models) and backplate in a location that can be
easily seen from the operator's position. Refer to the instructions for installing onto an
ATV for guidance.
3.4

Tank System

Micron Sprayers Ltd. recommends the use of Micron tank systems. If you have
purchased a tank system for use with the Spraydome/Undavina refer to the
instructions supplied with the tank system.
Install your tank system following the manufacturer's instructions. Do not connect the
tank system to your vehicles power supply except for the purposes of testing. The
electrical connection for the pump will be described in the electrical connections
section of this document. Do not connect the outlet of your tank system except for the
purposes of testing. The outlet connection will be described in the hose connections
section of this document.
Micron Sprayers Ltd. Spraydome/Undavina and Spraymiser
Installation