Installation; Content Of Package; Location - Labnet C0226R User Manual

3 Installation

Open the package. Take out the box containing the accessories. Take out centrifuge from the
container. Keep the box and packing materials in case of service shipping.

Content of package

name
Centrifuge Labnet C0226R
Complete clamp
Spanner for a rotor
Key for emergency lock release
Power cord 120V / power cord 230V
Fuse WTA T10 250V / WTA T6,3 250V
Petroleum jelly 20ml
USB A-A cable
user manual

Location

The device is heavy, so lifting and carrying the centrifuge can lead to back injuries.
Risk of injury while lifting and carrying heavy loads.
Lifting and transporting of the centrifuge should be done with a sufficient number
of helpers. Use a transport aid for transporting the centrifuge.
The device should be lifted by the underside in the vicinity of the its feet and
placed directly on a suitable lab table.
Ensure safe location.
The centrifuge shall not be located near source of heat and shall not be subjected
to direct sunlight.
Centrifuge should be flat-levelled. Efect of leveling shall be ensure by stable and
flat-levelled table top for the centrifuge.
Centrifuge should be set horizontally on a rigid base.
It is necessary to ensure a ventilation zone of the minimum 30cm round the
centrifuge from every direction. Do not veil ventilation holes !
Table for centifuge should posses safety zone of the minimum 30cm round the
centrifuge from every direction (safety needs in case of malfunction according to
EN 61010-020.
Table for centrifuge should be free of containtments before locating of centrifuge.
Passed parameters of the centrifuge are referring to the above named
temperatures (see 2.Technical specification).
At the change of the place from cold to warm one, condensation of water will
occur inside the centrifuge. It is important then that sufficient time be provided
for drying the centrifuge prior to starting the centrifuge again (min. 4 hours).
pcs
1
1
1
1
1
2
1
1
1
© 2018 Corning Incorporated
8