Related Manuals for Labnet MPS 1001 Mini Plate Spinner
Summary of Contents for Labnet MPS 1001 Mini Plate Spinner
- Page 1 Labnet MPS 1001 Mini Plate Spinner Instruction Manual Catalog Numbers: C1001 C1001-100V C1001-230V...
- Page 2 Table of Contents 1.0 Introduction ................. . .1 2.0 Symbols and Conventions .
- Page 3 1.0 Introduction The Labnet MPS-1001 Mini Plate Spinner is designed for quick spins of samples in PCR plates. Primarily designed for use with 96- or 384-well plates and small volumes, it will accommodate skirted, non-skirted and semi-skirted styles. With the use of the adapter you can spin a half plate, 8 or 12 x 0.2 μL strips, and individual PCR tubes.
- Page 4 5.0 Installation The Labnet MPS-1001 Mini Plate Spinner should be placed on a clean, flat surface with sufficient space around it for ventilation. Plug the power cord into the back of the unit, and connect the other end to the power socket. To turn on the unit, set the power switch to the On (I) position.
- Page 5 NOTES: A slight vibration may be felt when the centrifuge reaches full speed. Excessive vibration indicates that the rotor is not balanced. Do not run the centrifuge unbalanced. Always use a balance plate of the same brand, style, and sample volumes. The SHORT button is the electric mode button.
- Page 6 To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.
Need help?
Do you have a question about the MPS 1001 Mini Plate Spinner and is the answer not in the manual?
Questions and answers