Labnet C0226R User Manual page 40

Screen messages that may occur during operation.
MESSAGE
"SPEED OF ROTOR"
"IDENTIFICATION <> 90 RPM"
"IMBALANCE FAST STOP!"
"PLEASE REMOVE CAUSE"
"THEN RESTART"
"NO ROTOR OR IDENTIFICATION"
"SENSOR DAMAGED!"
"INCORRECT ROTOR NUMBER!"
"WRONG DIRECTION OF ROTATION"
"OR UNKNOWN ROTOR!"
"PLEASE CLOSE THE LID"
"HAND!"
"ROTOR STOPPING!"
"Please wait..."
" CYCLE'S ABORTED!"
" CYCLE'S FINISHED"
Emergency messages
In case of emergency messages (centrifuge is not working properly) contact the manufacturer's authorized service centre.
SPEED OF ROTOR IDENTIFICATION <> 90 RPM
ERROR OF ROTOR IDENTIFICATION {LIMIT OF 6SEC. IS OVER}
WRONG DIRECTION OF ROTATION / UNKNOWN ROTOR
INITIALIZING AFTER MAINS FAILURE WITH ROTATING
CENTRIFUGATION ENDED BECAUSE STOP WAS PRESSED
CENTRIFUGING ENDED {WITHOUT ERRORS}
MESSAGE
"OVERHEATING MOTOR!"
"INVERTER ERROR!"
"INVERTER SERIAL BUS ERROR!"
"TEMPERATURE SENSOR ERROR"
"OPENING COVER in RUN!"
"SPEED METER ERROR"
"I2C BUS ERROR"
"OVERHEATING CENTRIFUGE!"
"ROTOR OVERSPEED!"
"COVER LOCK MALFUNCTION!"
"WORKING 2000 HOURS:"
"CALL SERVICE FOR"
© 2018 Corning Incorporated
40
EXPLANATION
UNBALANCE DETECTED
ROTOR'S IS NOT CORRECT
CLOSING THE LID MANUALLY
ROTOR