Table of Contents
Advertisement
www.raisecom.com
5.1 Function and application of RC3000 host
5.1.1 Default setting
There is only hardware version of a new RC3000 and without any cross configuration. That is to say,
no cross setting and system setting but only set the device version by default. The version number
facilitates technicians to confirm device hardware and software version information when replacing
spare parts or maintenance device.
5.1.2 Self-check and startup
RC3000 will check all configurations after powered on, including: system configuration information,
cross connect configuration information, line-board information and sub-card information.
Meanwhile all LEDs will flicker and buzzer will buzz, otherwise there is error of some parts of
device.
5.1.3 Explanation of system automatic configuration in factory default status
RC3000 will configure itself according to hardware:
Configuration information not related to line-board:
Configuration information related to line-board:
RC3000-OPT-FE: single E1 direction.
RC3000-OPT-2E1: single E1 direction.
RC3000-4E1: single E1 direction.
Chapter 5 Function and Application
a. Device ID: not configured
b. Baud rate: not configured
c. Alarm mask: no alarm is masked.
d. CRC check: enable.
e. E1 mode: PCM30.
f. Alarm sound: enable
g. Assistant network management channel: occupying SA bit of time slot 0.
h. Clock switch mode: Automation.
a. Number of E1 interface:
RC3000-OPT-FE: E1 interfaces 1 and 2 are being used.
RC3000-OPT-2E1: E1 interfaces 1 and 2 are being used.
RC3000-4E1: E1 1 is used.
RC3000-2E1: E1 interfaces 1 and 2 are used in ADM mode, and only E1 1 is used when not
in ADM mode.
b. Network management topology direction:
User Manual
18
Advertisement
Table of Contents
