Table of Contents
Advertisement
www.raisecom.com
There are two parts information, one is the information saved in RAM and the other part is the
information saved in EEPROM.
A.4.7 Sub-card information (RAM)
In device set query menu press number key 7, there will be the prompt of user board number:
Then chose the sub-card number you want to query and there will be the sub-card information:
Note: System will display there is no definition for the card if input a user card number that is not
existed; the information is different according to user card type. State information of different types
of card is as below:
Card type 1 FXS audio user sub-card:
Card type 2 FXO audio relay sub-card:
Card type 3 FXO and FXS hybrid sub-card:
EEPROM Set:
1st E1 1=Mask
2nd E1 1=Mask
3rd E1 1=Mask
4th E1 1=Mask
Device Query Command:1-8, Menu Display: M, Return: Q
Input User Board No.(1-3, Esc=Cancel):
Sub-card X:
Type: user-card name
PCB version: REV A.3
(Set: real setting content)
Device Query Command:1-8, Menu Display: M, Return: Q
Type: 1 FXS sub-card
timeslot numbers: 8
PCB version: REV A.3
Signal: Have
Signal bit: (CH1:CH2): A A A A B B B B
Type: 2 FXO sub-card timeslot numbers: 8
PCB version: REV A.3
Signal: Have
Signal bit: (CH1:CH2): A A A A B B B B
Type: 3 FXS and FXO hybrid sub-card timeslot l numbers: 8
PCB version: REV A.3
Signal: Have
Signal bit:(CH1:CH2) : A A A A B B B B
Channel type:(CH1:CH2) : S S S S 0 0 0 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
timeslot Number: X
Set Mode: Hardware
CPLD version: REV 1.0
Set Mode: Hardware
CPLD version: REV 1.0
Input signal: Original signal
Set Mode: Hardware
CPLD version: REV 1.0
Input signal: Original signal
CPLD version: REV 1.0
Input signal: Original signal
0
0
0
0
0
0
0
0
0
0
0
0
Command:
Command:
Output signal: Reversal signal
Output signal: Reversal signal
Set Mode: Hardware
Output signal: Reversal signal
User Manual
55
Advertisement
Table of Contents
