Table of Contents
Advertisement
www.raisecom.com
5.1 Basic Connection
5.1.1 Connect the optical interface
Insert the well-prepared fiber patch cord into the optical interface on the front panel of the device.
The optical interface connection pattern is shown in Figure 5-1.
5.1.2 Connect the Agent network management interface
When connecting the device with the PC for network management, please connect the RJ-45
connector of the CBL-PCAGENT-DB9F/RJ45 cable to the LNK-UP interface of the device and
connect the DB-9 connector of the cable to the serial port of the PC.
5.1.3 Connect to the power supply
For device adopting 220V AC power supply, please plug the provided 220V AC power supply cable
to a 220V standard 3-phase power supply socket. For device adopting -48V DC power supply, please
connect the device with DC power supply using -48V DC power supply (connect the BGND
terminal of the DC power supply interface of the device to the earth of the power supply, connect the
-48V terminal to the -48V power supply, and connect the PGND terminal to protection earth). For
device using +24V or -24V DC power supply, the connecting is similar to that of the -48V DC power
supply.
Chapter 5 Basic Connection and Typical Application
Figure 5-1 The connection of the optical interface
User Manual
14
Advertisement
Table of Contents
