Table of Contents
Advertisement
www.raisecom.com
Sub-card type 15:
Sub-card type 16:
Other sub-cards without definition:
A.4.8 Sub-card information (EEPROM)
Device Set Query menu press number key 8 you can get the same information saved in EEPROM as
Sub-card information (RAM)
A.5 Cross Set Query menu:
In main menu press number key 2, there will be Cross Set Query menu:
Signal: None
Signal In: Original
Signal Bit(D7:D0):A A A A
Type: 15 Ethernet interface Board (version B)
PCB version: REV A.3
Signal: None
Channel: Main channel
Auto-negotiation: Enable
Default setting of auto-negotiation defeat: 100M Full-duplex
LINK state: LINK UP
Work state: 100M Full-duplex
Type: 16 Dual-Ethernet interface Board
PCB version: REV A.1
st
1
Ethernet info:
Timeslot number: 8
Auto-negotiation: Enable
LINK state: LINK UP
nd
2
Ethernet info:
Channel number: 4
Auto-negotiation: Enable
LINK state: LINK UP
Type: XX
Timeslot Number: X
PCB version: REV A.3
Signal: Exist
Setting content(CH1:CH2) : 0 0 0 0 0 0 0 0
State content(CH1:CH2) : 1 1 1 1 1 1 1 1
1.Four E1 Cross Query(RAM)
Signal Out: Reversal Original
Timeslot Number: 0
CPLD version: REV 1.0
Timeslot Number: 12
CPLD version: REV 1.0
Channel: Main channel
Default setting of auto-negotiation defeat: 100M Full-duplex
Work state: 100M Full-duplex
Channel: Independent channel
Default setting of auto-negotiation defeat: 100M Full-duplex
Work state: 100M Full-duplex
Set Mode: Hardware
CPLD version: REV 1.0
Mode 1: 0
Mode 2: 0
User Manual
Set Mode: Software
Set Mode: Software
59
Advertisement
Table of Contents
