Table of Contents
Advertisement
www.raisecom.com
sound.
A.9.8 User Board Set
In system menu press number key 8 to configure the sub-card:
If the relative sub-card does not exist, there will be the following information:
If the sub-card exists, then you can configure.
When sub-card types are: 1 (FXS user audio card), 2 (FXO audio relay card), 3 (FXS & FXO hybrid
card), 4 (EM2 audio relay card), 5 (EM4 audio relay card), 11 (magneto telephone card), 12 (FXS
polarity reversible card) and 14 (FXS polarity reversible card (-48V), the setting menu will be:
Note: the command explanation is available in A.13 User Board Set (with signal) menu.
Use following menu for 10-line card:
When the sub-card types is: 6 (V35 sub-card) the menu will be:
Note: the command explanation is available in A.14 V35 User Board Setting menu.
When the sub-card types is: 7 (V24 sub-card) the menu will be:
Input User Board No.(1-3, Esc=Cancel):
The First board is not exist.
System Set Command:1-8, Menu Display: M, Return: Q
1.Input Signal
2.Output Signal
3.Signal Bit
Sub-card1(FXS Board) Set Command:1-3, Menu Display: M, Return: Q
1.Input Signal
2.Output Signal
3.Signal Bit
4 10-line mode setting
Sub-card1(FXS Board) Set Command:1-4, Menu Display: M, Return: Q
1.Sub-Board Slot Number
2.Receive Data Phase
3.Transmit Data Phase
4.Channel Select
5.Loopback Set
6.Error Code Test
7.Auto to Adjust Phase for Transmit
8.To Adjust Receive Phase
Sub-card2(V35 User Board) Set Command:1-8, Menu Display: M, Return: Q
1.
Set bandwidth of port 1, phase adjust
Command:
Command:
Command:
Command:
User Manual
70
Advertisement
Table of Contents
